SP5BS-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5BS-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1753631252	449 Count	7 Count	7 Count
1753630651	448 Count	7 Count	7 Count
1753630050	447 Count	7 Count	7 Count
1753629450	446 Count	7 Count	7 Count
1753628849	445 Count	7 Count	7 Count
1753627908	443 Count	7 Count	7 Count
1753626735	441 Count	7 Count	7 Count
1753626134	440 Count	7 Count	7 Count
1753625533	439 Count	7 Count	7 Count
1753624933	438 Count	7 Count	7 Count
1753624332	437 Count	7 Count	7 Count
1753623731	436 Count	7 Count	7 Count
1753623130	435 Count	7 Count	7 Count
1753622529	434 Count	7 Count	7 Count
1753621928	433 Count	7 Count	7 Count
1753620126	430 Count	7 Count	7 Count
1753619525	429 Count	7 Count	7 Count
1753617121	425 Count	7 Count	7 Count
1753616520	424 Count	7 Count	7 Count
1753615919	420 Count	4 Count	4 Count
1753614717	418 Count	4 Count	4 Count
1753613515	416 Count	4 Count	4 Count
1753612915	415 Count	4 Count	4 Count
1753612314	414 Count	4 Count	4 Count
1753611713	413 Count	4 Count	4 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)