SP9KPS-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9KPS-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1788592467	16 Count	255 Count	15 Count
1788590667	9 Count	129 Count	9 Count
1788588866	92 Count	1176 Count	83 Count
1788587065	74 Count	957 Count	67 Count
1788585264	64 Count	765 Count	58 Count
1788583464	55 Count	619 Count	51 Count
1788581663	43 Count	480 Count	40 Count
1788579862	18 Count	301 Count	16 Count
1788578069	10 Count	154 Count	9 Count
1788576269	90 Count	1060 Count	80 Count
1788574468	70 Count	876 Count	61 Count
1788572667	53 Count	701 Count	46 Count
1788570866	42 Count	555 Count	36 Count
1788569066	32 Count	435 Count	28 Count
1788567265	26 Count	321 Count	23 Count
1788565464	17 Count	232 Count	15 Count
1788563663	7 Count	122 Count	7 Count
1788561863	68 Count	1055 Count	60 Count
1788560062	57 Count	933 Count	51 Count
1788558261	52 Count	824 Count	47 Count
1788556472	44 Count	700 Count	41 Count
1788551069	11 Count	148 Count	11 Count
1788545666	68 Count	744 Count	66 Count
1788543865	54 Count	586 Count	53 Count
1788542065	26 Count	337 Count	26 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)