ON4SAR-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ON4SAR-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1784675248	240 Count	992 Count	6 Count
1784671645	239 Count	984 Count	6 Count
1784668042	238 Count	978 Count	6 Count
1784664456	237 Count	973 Count	6 Count
1784639254	230 Count	927 Count	6 Count
1784635651	229 Count	921 Count	6 Count
1784632048	228 Count	916 Count	6 Count
1784628445	227 Count	910 Count	6 Count
1784624842	226 Count	903 Count	6 Count
1784621239	225 Count	898 Count	6 Count
1784617654	224 Count	893 Count	6 Count
1784614051	223 Count	887 Count	6 Count
1784610448	222 Count	881 Count	6 Count
1784606845	221 Count	875 Count	6 Count
1784603242	220 Count	871 Count	6 Count
1784599639	219 Count	863 Count	6 Count
1784596053	218 Count	853 Count	6 Count
1784592450	217 Count	845 Count	6 Count
1784588847	216 Count	838 Count	6 Count
1784585244	215 Count	832 Count	6 Count
1784581641	214 Count	826 Count	6 Count
1784578038	213 Count	822 Count	6 Count
1784574454	212 Count	817 Count	6 Count
1784570858	211 Count	812 Count	6 Count
1784567248	210 Count	808 Count	6 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)