M0IGA-0 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object M0IGA-0. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1753624557	80 Count	51 Count	45 Count
1753623356	77 Count	49 Count	43 Count
1753622156	76 Count	49 Count	43 Count
1753620955	73 Count	47 Count	41 Count
1753619754	72 Count	47 Count	41 Count
1753617797	53 Count	30 Count	24 Count
1753616596	39 Count	17 Count	11 Count
1753616400	37 Count	16 Count	10 Count
1753616170	35 Count	15 Count	9 Count
1753616064	34 Count	15 Count	9 Count
1753615890	32 Count	14 Count	8 Count
1753615512	30 Count	13 Count	7 Count
1753614510	27 Count	11 Count	5 Count
1753613309	23 Count	8 Count	2 Count
1753613134	20 Count	6 Count	0 Count
1753613103	19 Count	5 Count	0 Count
1753612947	18 Count	4 Count	0 Count
1753612909	17 Count	4 Count	0 Count
1753612773	16 Count	3 Count	0 Count
1753611206	10 Count	0 Count	0 Count
1753610764	5 Count	0 Count	0 Count
1753610597	0 Count	0 Count	0 Count
1753610397	0 Count	0 Count	0 Count
1753610291	0 Count	0 Count	0 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)