SQ2SIX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2SIX-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1761603150	35 Count	535 Count	35 Count
1761602544	35 Count	533 Count	35 Count
1761601944	35 Count	532 Count	35 Count
1761601344	35 Count	531 Count	35 Count
1761600744	35 Count	528 Count	35 Count
1761600144	35 Count	527 Count	35 Count
1761599544	35 Count	525 Count	35 Count
1761598944	35 Count	522 Count	35 Count
1761598344	35 Count	521 Count	35 Count
1761597744	35 Count	519 Count	35 Count
1761597144	35 Count	516 Count	35 Count
1761596544	35 Count	515 Count	35 Count
1761595343	35 Count	510 Count	35 Count
1761594743	35 Count	507 Count	35 Count
1761594143	35 Count	504 Count	35 Count
1761593554	35 Count	502 Count	35 Count
1761592943	35 Count	499 Count	35 Count
1761592349	35 Count	498 Count	35 Count
1761591743	35 Count	496 Count	35 Count
1761591143	35 Count	495 Count	35 Count
1761590544	35 Count	494 Count	35 Count
1761589343	35 Count	485 Count	35 Count
1761588743	35 Count	484 Count	35 Count
1761588143	35 Count	481 Count	35 Count
1761587543	35 Count	479 Count	35 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)