G1DIF-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object G1DIF-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*
1777075360	84 Count	69 Count
1777075258	79 Count	69 Count
1777069366	74 Count	69 Count
1777068463	73 Count	66 Count
1777067559	72 Count	61 Count
1777066656	71 Count	58 Count
1777065753	70 Count	53 Count
1777064849	69 Count	50 Count
1777063946	68 Count	45 Count
1777063043	67 Count	42 Count
1777062139	66 Count	38 Count
1777061236	65 Count	38 Count
1777060333	64 Count	35 Count
1777059430	63 Count	32 Count
1777058526	62 Count	27 Count
1777057623	61 Count	24 Count
1777056720	60 Count	19 Count
1777055816	59 Count	16 Count
1777054913	58 Count	11 Count
1777054010	57 Count	8 Count
1777053106	56 Count	3 Count
1777052203	55 Count	0 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)