IW9GTR-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IW9GTR-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1761580184	315 Count	941 Count	202 Count
1761578975	309 Count	921 Count	198 Count
1761576557	299 Count	889 Count	192 Count
1761575348	293 Count	875 Count	188 Count
1761574140	288 Count	860 Count	185 Count
1761572931	283 Count	844 Count	182 Count
1761571722	275 Count	829 Count	176 Count
1761570678	269 Count	818 Count	172 Count
1761569469	264 Count	804 Count	169 Count
1761568260	259 Count	791 Count	166 Count
1761565842	248 Count	754 Count	159 Count
1761564633	243 Count	723 Count	156 Count
1761563422	236 Count	692 Count	151 Count
1761561005	224 Count	647 Count	143 Count
1761559796	219 Count	622 Count	140 Count
1761558587	214 Count	605 Count	137 Count
1761557378	208 Count	590 Count	133 Count
1761556169	203 Count	567 Count	130 Count
1761554960	198 Count	550 Count	127 Count
1761553751	192 Count	534 Count	123 Count
1761552542	187 Count	519 Count	120 Count
1761551337	183 Count	505 Count	118 Count
1761550121	176 Count	489 Count	113 Count
1761549071	171 Count	477 Count	110 Count
1761547863	166 Count	464 Count	107 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)