OK4RS-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK4RS-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1755770238	730 Count	73 Count	73 Count
1755768437	729 Count	73 Count	73 Count
1755766637	728 Count	73 Count	73 Count
1755764836	727 Count	73 Count	73 Count
1755763035	726 Count	73 Count	73 Count
1755761234	725 Count	73 Count	73 Count
1755759434	724 Count	73 Count	73 Count
1755757642	723 Count	73 Count	73 Count
1755755841	722 Count	73 Count	73 Count
1755754041	721 Count	73 Count	73 Count
1755752240	720 Count	73 Count	73 Count
1755750439	719 Count	73 Count	73 Count
1755748638	718 Count	73 Count	73 Count
1755746837	717 Count	73 Count	73 Count
1755745037	716 Count	73 Count	73 Count
1755743236	715 Count	73 Count	73 Count
1755741435	714 Count	73 Count	73 Count
1755739635	713 Count	73 Count	73 Count
1755737838	712 Count	73 Count	73 Count
1755714441	699 Count	73 Count	73 Count
1755712640	698 Count	73 Count	73 Count
1755710839	697 Count	73 Count	73 Count
1755709039	696 Count	73 Count	73 Count
1755707238	695 Count	73 Count	73 Count
1755705437	694 Count	73 Count	73 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)