OE7XLI-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OE7XLI-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Vin*	Eff1h*
1753667950	12.88 Volt	100 Pcnt
1753666150	12.88 Volt	100 Pcnt
1753662550	12.88 Volt	100 Pcnt
1753660750	12.88 Volt	100 Pcnt
1753657151	12.88 Volt	100 Pcnt
1753655351	12.88 Volt	100 Pcnt
1753653551	12.88 Volt	100 Pcnt
1753651751	12.88 Volt	100 Pcnt
1753649951	12.88 Volt	100 Pcnt
1753648151	12.88 Volt	100 Pcnt
1753646351	12.88 Volt	100 Pcnt
1753644551	12.88 Volt	100 Pcnt
1753642751	12.88 Volt	100 Pcnt
1753640951	12.88 Volt	100 Pcnt
1753639151	12.88 Volt	100 Pcnt
1753637351	12.88 Volt	100 Pcnt
1753635551	12.88 Volt	100 Pcnt
1753633751	12.88 Volt	100 Pcnt
1753631951	12.88 Volt	100 Pcnt
1753630151	12.88 Volt	100 Pcnt
1753628351	12.88 Volt	100 Pcnt
1753626551	12.88 Volt	100 Pcnt
1753621180	12.88 Volt	0 Pcnt
1753619380	12.88 Volt	0 Pcnt
1753617579	12.88 Volt	100 Pcnt

*Used Equation Coefficients:

Vin: 0, 0.079, 0

Rx1h: 0, 10, 0

Dg1h: 0, 10, 0

Eff1h: 0, 1, 0

A5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)