SP5MSV-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5MSV-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789965683	0 Count	0 Count	0 Count
1789963882	1000 Count	161 Count	39 Count
1789962081	999 Count	161 Count	39 Count
1789960281	998 Count	161 Count	39 Count
1789958480	997 Count	161 Count	39 Count
1789956679	996 Count	161 Count	39 Count
1789954879	995 Count	161 Count	39 Count
1789953078	994 Count	161 Count	39 Count
1789951285	993 Count	161 Count	39 Count
1789949485	992 Count	161 Count	39 Count
1789947707	991 Count	161 Count	39 Count
1789945883	990 Count	161 Count	39 Count
1789944093	989 Count	161 Count	39 Count
1789942282	988 Count	161 Count	39 Count
1789940481	987 Count	161 Count	39 Count
1789938680	986 Count	161 Count	39 Count
1789936880	985 Count	161 Count	39 Count
1789935079	984 Count	161 Count	39 Count
1789933278	983 Count	161 Count	39 Count
1789931477	982 Count	161 Count	39 Count
1789929686	981 Count	161 Count	39 Count
1789927885	980 Count	161 Count	39 Count
1789926085	979 Count	161 Count	39 Count
1789924284	977 Count	160 Count	38 Count
1789922482	975 Count	159 Count	37 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)