SQ4HSE-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ4HSE-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1773260782	100 Count	166 Count	73 Count
1773257181	97 Count	160 Count	71 Count
1773253582	93 Count	154 Count	68 Count
1773249979	90 Count	148 Count	66 Count
1773246379	86 Count	141 Count	63 Count
1773242780	83 Count	136 Count	61 Count
1773239244	79 Count	129 Count	58 Count
1773235643	76 Count	124 Count	56 Count
1773228441	69 Count	111 Count	51 Count
1773224840	65 Count	106 Count	48 Count
1773221239	62 Count	102 Count	46 Count
1773217638	55 Count	92 Count	40 Count
1773214037	52 Count	86 Count	38 Count
1773210436	49 Count	80 Count	36 Count
1773206835	46 Count	75 Count	34 Count
1773203234	42 Count	69 Count	31 Count
1773199633	39 Count	64 Count	29 Count
1773196033	32 Count	51 Count	23 Count
1773192432	29 Count	45 Count	21 Count
1773188831	25 Count	39 Count	18 Count
1773185230	22 Count	34 Count	16 Count
1773181629	18 Count	28 Count	13 Count
1773178028	15 Count	25 Count	11 Count
1773174427	12 Count	21 Count	9 Count
1773170826	9 Count	16 Count	7 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)