IZ5IOM-14 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IZ5IOM-14. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*
1787591279	7 Count	386 Count
1787589476	6 Count	324 Count
1787587672	5 Count	273 Count
1787585908	4 Count	227 Count
1787584105	3 Count	188 Count
1787582302	2 Count	145 Count
1787580498	1 Count	102 Count
1787578695	0 Count	42 Count
1787576891	21 Count	1040 Count
1787575088	20 Count	971 Count
1787573285	19 Count	916 Count
1787571481	18 Count	864 Count
1787569678	17 Count	822 Count
1787567874	16 Count	782 Count
1787566071	15 Count	720 Count
1787564308	14 Count	676 Count
1787562504	13 Count	636 Count
1787560701	12 Count	590 Count
1787558897	11 Count	528 Count
1787557094	10 Count	483 Count
1787555291	9 Count	439 Count
1787553487	8 Count	398 Count
1787551684	7 Count	347 Count
1787549880	6 Count	293 Count
1787548077	5 Count	236 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)