SP3LSN-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3LSN-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1765540558	449 Count	164 Count	27 Count
1765538758	446 Count	152 Count	25 Count
1765536957	443 Count	133 Count	23 Count
1765533356	438 Count	113 Count	20 Count
1765531555	436 Count	102 Count	19 Count
1765529755	432 Count	89 Count	16 Count
1765527954	429 Count	80 Count	14 Count
1765526153	426 Count	67 Count	12 Count
1765524353	425 Count	63 Count	12 Count
1765522552	423 Count	55 Count	11 Count
1765520751	422 Count	53 Count	11 Count
1765518959	420 Count	43 Count	10 Count
1765517158	418 Count	40 Count	9 Count
1765515358	415 Count	36 Count	7 Count
1765513557	413 Count	32 Count	6 Count
1765511756	411 Count	25 Count	5 Count
1765509955	408 Count	17 Count	3 Count
1765508154	406 Count	11 Count	2 Count
1765506354	404 Count	8 Count	1 Count
1765497358	398 Count	5 Count	0 Count
1765495557	397 Count	5 Count	0 Count
1765493756	396 Count	5 Count	0 Count
1765491956	395 Count	5 Count	0 Count
1765490155	394 Count	5 Count	0 Count
1765488354	393 Count	5 Count	0 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)