SR2ST-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2ST-11. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1761489481	905 Count	788 Count	788 Count
1761485825	895 Count	788 Count	788 Count
1761484144	854 Count	748 Count	748 Count
1761483289	849 Count	748 Count	748 Count
1761481608	825 Count	725 Count	725 Count
1761479927	806 Count	707 Count	707 Count
1761478246	781 Count	683 Count	683 Count
1761476565	754 Count	657 Count	657 Count
1761474884	716 Count	620 Count	620 Count
1761473203	681 Count	586 Count	586 Count
1761471522	653 Count	559 Count	559 Count
1761469841	634 Count	541 Count	541 Count
1761468159	624 Count	532 Count	532 Count
1761467733	619 Count	532 Count	532 Count
1761465477	609 Count	532 Count	532 Count
1761463796	584 Count	508 Count	508 Count
1761462718	573 Count	507 Count	507 Count
1761461036	521 Count	456 Count	456 Count
1761459355	477 Count	413 Count	413 Count
1761454111	435 Count	387 Count	387 Count
1761454064	430 Count	387 Count	387 Count
1761450702	374 Count	333 Count	333 Count
1761443008	226 Count	194 Count	194 Count
1761441327	211 Count	180 Count	180 Count
1761440558	206 Count	180 Count	180 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)