PY2BIL-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PY2BIL-3. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Battery*	Charging/AC*	GPS+Sat*
1774633828	60 Percent	48 Charge/On/Off	2 Sats/On/Off
1774633587	60 Percent	48 Charge/On/Off	2 Sats/On/Off
1774632627	60 Percent	48 Charge/On/Off	2 Sats/On/Off
1774631667	60 Percent	48 Charge/On/Off	2 Sats/On/Off
1774630707	60 Percent	48 Charge/On/Off	2 Sats/On/Off
1774629807	60 Percent	48 Charge/On/Off	2 Sats/On/Off
1774628847	60 Percent	48 Charge/On/Off	2 Sats/On/Off
1774627947	60 Percent	48 Charge/On/Off	2 Sats/On/Off
1774626989	60 Percent	48 Charge/On/Off	2 Sats/On/Off
1774626027	60 Percent	48 Charge/On/Off	2 Sats/On/Off
1774625127	60 Percent	48 Charge/On/Off	2 Sats/On/Off
1774624167	60 Percent	48 Charge/On/Off	2 Sats/On/Off
1774623267	60 Percent	48 Charge/On/Off	2 Sats/On/Off
1774623147	60 Percent	48 Charge/On/Off	2 Sats/On/Off
1774622728	60 Percent	48 Charge/On/Off	2 Sats/On/Off
1774622187	60 Percent	48 Charge/On/Off	2 Sats/On/Off

*Used Equation Coefficients:

Battery: 0, 1, 0

Charging/AC: 0, 1, 0

GPS+Sat: 0, 1, 0

Current: 0, 10, -1280

A5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)