SP1APG-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP1APG-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1772552366	395 Count	607 Count	141 Count
1772550580	395 Count	607 Count	141 Count
1772548766	395 Count	607 Count	141 Count
1772546965	395 Count	607 Count	141 Count
1772545176	395 Count	607 Count	141 Count
1772543365	395 Count	607 Count	141 Count
1772541565	395 Count	607 Count	141 Count
1772539765	395 Count	607 Count	141 Count
1772537965	395 Count	607 Count	141 Count
1772536165	395 Count	607 Count	141 Count
1772534365	395 Count	607 Count	141 Count
1772532565	395 Count	607 Count	141 Count
1772530765	395 Count	607 Count	141 Count
1772528965	395 Count	607 Count	141 Count
1772527165	395 Count	607 Count	141 Count
1772525365	395 Count	607 Count	141 Count
1772523564	395 Count	607 Count	141 Count
1772521764	395 Count	607 Count	141 Count
1772519964	395 Count	607 Count	141 Count
1772518164	395 Count	607 Count	141 Count
1772516364	395 Count	607 Count	141 Count
1772514564	395 Count	607 Count	141 Count
1772512764	395 Count	607 Count	141 Count
1772510964	395 Count	607 Count	141 Count
1772509164	395 Count	607 Count	141 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)