SR9SRC-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR9SRC-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1757572472	49 Count	815 Count
1757571871	48 Count	808 Count
1757571270	47 Count	795 Count
1757570670	46 Count	793 Count
1757570069	45 Count	776 Count
1757569468	44 Count	764 Count
1757568867	43 Count	750 Count
1757568267	42 Count	739 Count
1757567666	41 Count	729 Count
1757567065	40 Count	721 Count
1757566464	39 Count	706 Count
1757565864	38 Count	697 Count
1757565263	37 Count	681 Count
1757564662	36 Count	655 Count
1757564062	35 Count	629 Count
1757563461	34 Count	620 Count
1757562860	33 Count	600 Count
1757562260	32 Count	589 Count
1757561685	31 Count	573 Count
1757561084	30 Count	566 Count
1757560484	29 Count	557 Count
1757559883	28 Count	543 Count
1757559282	27 Count	524 Count
1757558682	26 Count	511 Count
1757558081	25 Count	488 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)