OK1OBR-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1OBR-11. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1789939469	16 Count	349 Count
1789937666	15 Count	302 Count
1789935863	14 Count	259 Count
1789934081	10 Count	223 Count
1789932256	9 Count	176 Count
1789930452	8 Count	116 Count
1789928649	7 Count	85 Count
1789926846	2 Count	62 Count
1789925042	1 Count	39 Count
1789923238	0 Count	17 Count
1789921525	60 Count	1007 Count
1789919722	57 Count	980 Count
1789917918	56 Count	952 Count
1789916115	55 Count	931 Count
1789914311	54 Count	903 Count
1789912508	50 Count	876 Count
1789910705	49 Count	849 Count
1789908901	48 Count	814 Count
1789907097	47 Count	788 Count
1789905294	43 Count	759 Count
1789903490	42 Count	723 Count
1789901687	41 Count	699 Count
1789900189	40 Count	698 Count
1789898386	36 Count	693 Count
1789896582	35 Count	678 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)