PI8ZLB-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PI8ZLB-3. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1757234214	45	36	27	21	114
1757233011	46	36	27	21	114
1757231794	46	36	27	21	114
1757229374	45	36	27	21	114
1757228165	46	36	26	21	114
1757226980	45	35	26	21	114
1757225747	45	35	26	20	114
1757224535	44	34	26	20	113
1757223328	44	34	25	20	114
1757222115	44	34	26	20	113
1757220906	44	34	26	20	114
1757219695	44	34	25	20	113
1757218488	44	35	26	20	113
1757217276	44	35	26	20	114
1757216066	44	34	25	20	114
1757214856	44	34	26	20	113
1757213646	44	34	25	20	113
1757212436	44	34	25	20	113
1757211226	44	34	26	20	113
1757208806	44	35	26	20	113
1757207596	44	34	26	20	113
1757206392	44	35	26	20	114
1757205176	44	34	26	20	113
1757203970	44	34	26	20	114
1757202756	44	35	26	20	113

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)