9W8ASH-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object 9W8ASH-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1782126356	358 Count	733 Count	356 Count
1782119152	232 Count	522 Count	231 Count
1782111949	103 Count	242 Count	103 Count
1782104755	544 Count	1253 Count	539 Count
1782097551	437 Count	999 Count	433 Count
1782090348	315 Count	697 Count	312 Count
1782083157	208 Count	488 Count	206 Count
1782075953	90 Count	158 Count	89 Count
1782061554	474 Count	896 Count	471 Count
1782054350	368 Count	639 Count	366 Count
1782047147	262 Count	463 Count	261 Count
1782039953	110 Count	192 Count	110 Count
1782032753	511 Count	1152 Count	507 Count
1782025545	371 Count	770 Count	368 Count
1782018356	272 Count	548 Count	270 Count
1782003948	0 Count	0 Count	0 Count
1781996752	454 Count	789 Count	449 Count
1781989548	349 Count	627 Count	345 Count
1781982345	267 Count	490 Count	264 Count
1781975151	183 Count	346 Count	181 Count
1781967947	95 Count	197 Count	94 Count
1781960744	0 Count	0 Count	0 Count
1781953554	482 Count	959 Count	479 Count
1781946350	353 Count	718 Count	351 Count
1781939146	206 Count	466 Count	205 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)