IT9IRS-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IT9IRS-11. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1784702153	276 Count	482 Count	135 Count
1784701849	271 Count	475 Count	131 Count
1784701544	269 Count	473 Count	130 Count
1784701240	267 Count	466 Count	129 Count
1784700932	262 Count	459 Count	125 Count
1784700627	261 Count	454 Count	125 Count
1784700323	259 Count	448 Count	124 Count
1784700018	256 Count	445 Count	122 Count
1784699714	254 Count	442 Count	121 Count
1784699410	252 Count	436 Count	120 Count
1784698496	245 Count	410 Count	116 Count
1784698192	243 Count	407 Count	115 Count
1784697278	239 Count	399 Count	114 Count
1784692713	212 Count	338 Count	102 Count
1784692103	209 Count	330 Count	101 Count
1784691202	199 Count	316 Count	98 Count
1784690898	197 Count	314 Count	97 Count
1784690593	194 Count	308 Count	95 Count
1784690289	192 Count	303 Count	94 Count
1784689984	190 Count	299 Count	93 Count
1784689680	189 Count	295 Count	93 Count
1784689376	187 Count	291 Count	92 Count
1784689071	185 Count	289 Count	91 Count
1784688767	184 Count	288 Count	91 Count
1784688463	182 Count	285 Count	90 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)