SP6QKX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6QKX-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1761561652	808 Count	23 Count	12 Count
1761554432	804 Count	23 Count	12 Count
1761550822	802 Count	23 Count	12 Count
1761547212	800 Count	23 Count	12 Count
1761543602	798 Count	23 Count	12 Count
1761539992	796 Count	23 Count	12 Count
1761536382	794 Count	23 Count	12 Count
1761532772	792 Count	23 Count	12 Count
1761529162	790 Count	23 Count	12 Count
1761525552	788 Count	23 Count	12 Count
1761521942	786 Count	23 Count	12 Count
1761518332	784 Count	23 Count	12 Count
1761514722	782 Count	23 Count	12 Count
1761511113	780 Count	23 Count	12 Count
1761507503	778 Count	23 Count	12 Count
1761503893	776 Count	23 Count	12 Count
1761500290	774 Count	23 Count	12 Count
1761496908	772 Count	23 Count	12 Count
1761489688	768 Count	23 Count	12 Count
1761486078	766 Count	23 Count	12 Count
1761482468	764 Count	23 Count	12 Count
1761478858	762 Count	23 Count	12 Count
1761475248	760 Count	23 Count	12 Count
1761468028	756 Count	23 Count	12 Count
1761464418	754 Count	23 Count	12 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)