SP6NIP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6NIP-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1763533636	424 Count	446 Count	147 Count
1763527650	394 Count	383 Count	123 Count
1763525849	385 Count	365 Count	116 Count
1763524047	374 Count	345 Count	107 Count
1763522246	364 Count	327 Count	99 Count
1763520444	354 Count	312 Count	91 Count
1763518643	345 Count	292 Count	84 Count
1763516842	336 Count	275 Count	77 Count
1763515040	326 Count	255 Count	69 Count
1763513239	317 Count	239 Count	62 Count
1763511437	307 Count	223 Count	54 Count
1763509636	298 Count	209 Count	47 Count
1763506959	285 Count	185 Count	39 Count
1763506914	284 Count	185 Count	39 Count
1763506823	283 Count	184 Count	39 Count
1763506737	281 Count	180 Count	38 Count
1763506693	280 Count	180 Count	38 Count
1763506633	278 Count	176 Count	37 Count
1763506572	277 Count	175 Count	37 Count
1763506511	276 Count	174 Count	37 Count
1763506390	273 Count	172 Count	36 Count
1763506329	272 Count	170 Count	36 Count
1763506268	271 Count	169 Count	36 Count
1763506086	267 Count	165 Count	35 Count
1763506025	266 Count	164 Count	35 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)