EA4GMY-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4GMY-3. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1761540841	603 Count	523 Count	438 Count
1761539938	601 Count	521 Count	437 Count
1761539034	599 Count	519 Count	436 Count
1761538131	597 Count	516 Count	435 Count
1761537232	595 Count	514 Count	434 Count
1761536406	589 Count	512 Count	433 Count
1761535498	584 Count	507 Count	429 Count
1761533692	580 Count	502 Count	427 Count
1761531889	576 Count	498 Count	425 Count
1761530078	572 Count	493 Count	423 Count
1761529175	570 Count	491 Count	422 Count
1761528272	568 Count	489 Count	421 Count
1761527368	566 Count	486 Count	420 Count
1761526465	564 Count	484 Count	419 Count
1761525562	562 Count	482 Count	418 Count
1761524658	560 Count	480 Count	417 Count
1761523755	558 Count	477 Count	416 Count
1761522852	556 Count	475 Count	415 Count
1761521948	554 Count	473 Count	414 Count
1761521045	552 Count	471 Count	413 Count
1761520141	550 Count	469 Count	412 Count
1761518334	546 Count	465 Count	410 Count
1761517430	544 Count	463 Count	409 Count
1761516530	542 Count	461 Count	408 Count
1761514797	534 Count	457 Count	406 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)