HS9BZG-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object HS9BZG-3. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RF->INET*	AllCount*
1773373909	1 Pkts	1 Pkts
1773373309	1 Pkts	1 Pkts
1773372709	3 Pkts	3 Pkts
1773372109	2 Pkts	2 Pkts
1773371509	2 Pkts	2 Pkts
1773370909	2 Pkts	2 Pkts
1773370309	1 Pkts	1 Pkts
1773369709	2 Pkts	2 Pkts
1773369109	1 Pkts	1 Pkts
1773368512	0 Pkts	0 Pkts
1773367909	3 Pkts	3 Pkts
1773367309	3 Pkts	3 Pkts
1773366709	2 Pkts	2 Pkts
1773366109	3 Pkts	3 Pkts
1773365509	3 Pkts	3 Pkts
1773364909	1 Pkts	1 Pkts
1773364309	6 Pkts	6 Pkts
1773363709	3 Pkts	3 Pkts
1773363109	1 Pkts	1 Pkts
1773362509	13 Pkts	13 Pkts
1773361909	14 Pkts	14 Pkts
1773361309	6 Pkts	6 Pkts
1773360709	3 Pkts	3 Pkts
1773360109	3 Pkts	3 Pkts
1773359509	2 Pkts	2 Pkts

*Used Equation Coefficients:

RF->INET: 0, 1, 0

INET->RF: 0, 1, 0

Repeater: 0, 1, 0

AllCount: 0, 1, 0

AllDrop: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)