SM0UQT-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SM0UQT-11. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1765552497	7 Count	151 Count
1765551594	6 Count	145 Count
1765550452	4 Count	137 Count
1765548659	2 Count	104 Count
1765546839	0 Count	42 Count
1765541415	77 Count	936 Count
1765539226	74 Count	885 Count
1765537420	72 Count	848 Count
1765535613	70 Count	795 Count
1765532176	69 Count	795 Count
1765531273	68 Count	789 Count
1765530369	67 Count	776 Count
1765529466	66 Count	769 Count
1765528563	65 Count	754 Count
1765527660	64 Count	752 Count
1765526756	63 Count	744 Count
1765525853	62 Count	737 Count
1765524949	61 Count	703 Count
1765524046	60 Count	663 Count
1765523143	59 Count	653 Count
1765522240	58 Count	646 Count
1765521336	57 Count	630 Count
1765520433	56 Count	620 Count
1765519529	55 Count	608 Count
1765518626	54 Count	600 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)