SP4HMU-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP4HMU-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1788630919	58 Count	468 Count	21 Count
1788630318	56 Count	454 Count	20 Count
1788629718	55 Count	444 Count	20 Count
1788629117	53 Count	430 Count	19 Count
1788628516	51 Count	415 Count	18 Count
1788627916	50 Count	404 Count	18 Count
1788627315	48 Count	391 Count	17 Count
1788626714	46 Count	377 Count	16 Count
1788626114	45 Count	359 Count	16 Count
1788625513	43 Count	345 Count	15 Count
1788624913	42 Count	333 Count	15 Count
1788624312	41 Count	324 Count	15 Count
1788623711	40 Count	314 Count	15 Count
1788623111	39 Count	303 Count	15 Count
1788622509	38 Count	293 Count	15 Count
1788621908	37 Count	282 Count	15 Count
1788621308	36 Count	269 Count	15 Count
1788620712	35 Count	258 Count	15 Count
1788620107	34 Count	248 Count	15 Count
1788619506	33 Count	238 Count	15 Count
1788618905	32 Count	228 Count	15 Count
1788618305	31 Count	217 Count	15 Count
1788617704	30 Count	207 Count	15 Count
1788617103	29 Count	198 Count	15 Count
1788616503	28 Count	188 Count	15 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)