F4IZM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4IZM-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1784692566	351 Count	619 Count	287 Count
1784690761	346 Count	609 Count	283 Count
1784688956	341 Count	598 Count	279 Count
1784687151	336 Count	588 Count	275 Count
1784685346	331 Count	578 Count	271 Count
1784683540	326 Count	567 Count	267 Count
1784681736	321 Count	558 Count	263 Count
1784679931	316 Count	547 Count	259 Count
1784678126	311 Count	538 Count	255 Count
1784676321	306 Count	529 Count	251 Count
1784674530	301 Count	519 Count	247 Count
1784672711	296 Count	508 Count	243 Count
1784670906	291 Count	498 Count	239 Count
1784669100	286 Count	487 Count	235 Count
1784667295	281 Count	476 Count	231 Count
1784665491	276 Count	466 Count	227 Count
1784663686	271 Count	456 Count	223 Count
1784661880	266 Count	447 Count	219 Count
1784660075	261 Count	440 Count	215 Count
1784658271	256 Count	433 Count	211 Count
1784656466	251 Count	425 Count	207 Count
1784654661	247 Count	420 Count	204 Count
1784652856	242 Count	412 Count	200 Count
1784651069	237 Count	405 Count	196 Count
1784649246	228 Count	392 Count	188 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)