SP5XTF-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5XTF-3. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1784738327	622 Count	207 Count	150 Count
1784737426	621 Count	207 Count	150 Count
1784736525	620 Count	207 Count	150 Count
1784735625	619 Count	207 Count	150 Count
1784734724	618 Count	207 Count	150 Count
1784733823	617 Count	207 Count	150 Count
1784732923	610 Count	201 Count	144 Count
1784732039	606 Count	196 Count	141 Count
1784731139	605 Count	196 Count	141 Count
1784730238	603 Count	195 Count	140 Count
1784729337	602 Count	195 Count	140 Count
1784728436	601 Count	195 Count	140 Count
1784727536	600 Count	195 Count	140 Count
1784726635	598 Count	188 Count	139 Count
1784725734	597 Count	188 Count	139 Count
1784724834	596 Count	188 Count	139 Count
1784723933	595 Count	188 Count	139 Count
1784723033	594 Count	188 Count	139 Count
1784722132	593 Count	188 Count	139 Count
1784721231	592 Count	188 Count	139 Count
1784720331	591 Count	188 Count	139 Count
1784719430	590 Count	188 Count	139 Count
1784718529	589 Count	188 Count	139 Count
1784717628	588 Count	188 Count	139 Count
1784716728	587 Count	188 Count	139 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)