IT9IRS-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IT9IRS-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1776690868	72 Count	848 Count
1776689065	71 Count	832 Count
1776687262	70 Count	786 Count
1776685496	65 Count	741 Count
1776683692	64 Count	715 Count
1776681889	63 Count	670 Count
1776680086	62 Count	661 Count
1776678283	61 Count	635 Count
1776676480	60 Count	620 Count
1776674677	59 Count	611 Count
1776672874	58 Count	605 Count
1776671071	57 Count	600 Count
1776669268	56 Count	579 Count
1776667465	55 Count	551 Count
1776665662	54 Count	529 Count
1776663889	49 Count	516 Count
1776662086	48 Count	506 Count
1776660283	47 Count	491 Count
1776658480	46 Count	479 Count
1776656677	45 Count	470 Count
1776654874	44 Count	461 Count
1776653071	43 Count	452 Count
1776651268	42 Count	444 Count
1776649465	41 Count	432 Count
1776647662	40 Count	420 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)