BWMTN Telemetry

This is the latest recevied telemetry packets stored in our database for station/object BWMTN. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Vin*	Rx1h*
1788609801	12.38 Volt	410 Pkt
1788608001	12.38 Volt	460 Pkt
1788606201	12.38 Volt	460 Pkt
1788604401	12.38 Volt	430 Pkt
1788602601	12.38 Volt	450 Pkt
1788600801	12.38 Volt	430 Pkt
1788599001	12.38 Volt	420 Pkt
1788597201	12.38 Volt	430 Pkt
1788595401	12.38 Volt	440 Pkt
1788593601	12.38 Volt	470 Pkt
1788591801	12.38 Volt	500 Pkt
1788590001	12.38 Volt	500 Pkt
1788588201	12.38 Volt	480 Pkt
1788586401	12.38 Volt	470 Pkt
1788584601	12.38 Volt	530 Pkt
1788582801	12.38 Volt	520 Pkt
1788581002	12.38 Volt	460 Pkt
1788579202	12.38 Volt	560 Pkt
1788577401	12.38 Volt	620 Pkt
1788575602	12.38 Volt	560 Pkt
1788573802	12.38 Volt	510 Pkt
1788572002	12.38 Volt	550 Pkt
1788570202	12.38 Volt	590 Pkt
1788568402	12.38 Volt	550 Pkt
1788566602	12.38 Volt	590 Pkt

*Used Equation Coefficients:

Vin: 0, 0.075, 0

Rx1h: 0, 10, 0

Dg1h: 0, 10, 0

Eff1h: 0, 1, 0

A5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)