DB0PBG-5 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DB0PBG-5. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Vin*	Temp*
1757420786	14.18 Volt	21 C
1757420486	14.18 Volt	21 C
1757420186	14.18 Volt	21 C
1757419886	14.18 Volt	21.5 C
1757419585	14.18 Volt	21 C
1757419285	14.18 Volt	21.5 C
1757418985	14.18 Volt	21 C
1757418684	14.18 Volt	21 C
1757418384	14.18 Volt	21 C
1757418084	14.18 Volt	21 C
1757417784	14.18 Volt	21 C
1757417483	14.03 Volt	21 C
1757417183	14.18 Volt	21 C
1757416883	14.18 Volt	21 C
1757416582	14.18 Volt	21 C
1757416282	14.18 Volt	21 C
1757415982	14.18 Volt	21 C
1757415681	14.18 Volt	21 C
1757415381	14.18 Volt	21 C
1757415081	14.18 Volt	21 C
1757414781	14.18 Volt	21 C
1757414480	14.18 Volt	21 C
1757414180	14.18 Volt	21 C
1757413880	13.95 Volt	21 C
1757413580	14.18 Volt	21 C

*Used Equation Coefficients:

Vin: 0, 0.075, 0

Temp: 0, 0.5, -64

Dg1h: 0, 10, 0

Eff1h: 0, 1, 0

A5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)