F1ZZM-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F1ZZM-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Rx ed*	Dig ed*	Decode*
1784685466	51 Packet	10 Packet	60 %
1784681798	39 Packet	6 Packet	54 %
1784678138	39 Packet	9 Packet	52 %
1784674478	39 Packet	9 Packet	55 %
1784670818	43 Packet	9 Packet	61 %
1784667159	49 Packet	9 Packet	68 %
1784663498	40 Packet	7 Packet	67 %
1784656179	49 Packet	10 Packet	68 %
1784648859	49 Packet	7 Packet	63 %
1784645198	50 Packet	8 Packet	66 %
1784641539	52 Packet	11 Packet	67 %
1784634219	56 Packet	12 Packet	66 %
1784630559	59 Packet	13 Packet	69 %
1784626899	61 Packet	10 Packet	67 %
1784623240	61 Packet	11 Packet	64 %
1784619579	66 Packet	13 Packet	70 %
1784615919	75 Packet	11 Packet	75 %
1784612259	71 Packet	12 Packet	77 %
1784608599	73 Packet	13 Packet	74 %
1784604939	63 Packet	11 Packet	73 %
1784601279	53 Packet	7 Packet	71 %
1784597619	51 Packet	8 Packet	70 %
1784593959	55 Packet	8 Packet	75 %
1784590299	54 Packet	9 Packet	72 %
1784586640	48 Packet	8 Packet	66 %

*Used Equation Coefficients:

Vin: 0, 0.079, 0

Rx ed: 0, 1, 0

Dig ed: 0, 1, 0

Decode: 0, 1, 0

Value5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)