DB9EP-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DB9EP-12. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Temp.in*	Temp.out*
1780901313	0 C deg	17.6 C deg
1780901309	0 C deg	17.6 C deg
1780899499	0 C deg	16.7 C deg
1780899494	0 C deg	16.7 C deg
1780897684	0 C deg	15.4 C deg
1780897679	0 C deg	15.4 C deg
1780895865	0 C deg	13.7 C deg
1780895864	0 C deg	13.7 C deg
1780894058	0 C deg	12.4 C deg
1780894048	0 C deg	12.4 C deg
1780892236	0 C deg	11.5 C deg
1780892233	0 C deg	11.5 C deg
1780890418	0 C deg	11.8 C deg
1780888603	0 C deg	12.5 C deg
1780886792	0 C deg	12.3 C deg
1780886788	0 C deg	12.3 C deg
1780884975	0 C deg	12.3 C deg
1780884973	0 C deg	12.3 C deg
1780883161	0 C deg	11.8 C deg
1780883158	0 C deg	11.8 C deg
1780881351	0 C deg	12.4 C deg
1780881343	0 C deg	12.4 C deg
1780879532	0 C deg	12.4 C deg
1780879528	0 C deg	12.4 C deg
1780877717	0 C deg	12.6 C deg

*Used Equation Coefficients:

Press: 0, 1, 0

Temp.in: 0, 1, 0

Hum: 0, 1, 0

QNH: 0, 1, 0

Temp.out: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)