SP8HDC-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8HDC-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1787565414	922 Count	772 Count	292 Count
1787563613	921 Count	772 Count	292 Count
1787561820	920 Count	772 Count	292 Count
1787560019	900 Count	753 Count	273 Count
1787558218	888 Count	742 Count	262 Count
1787556418	887 Count	742 Count	262 Count
1787554617	886 Count	742 Count	262 Count
1787552816	885 Count	742 Count	262 Count
1787551016	884 Count	742 Count	262 Count
1787549215	883 Count	742 Count	262 Count
1787547414	882 Count	742 Count	262 Count
1787545613	881 Count	742 Count	262 Count
1787543813	880 Count	742 Count	262 Count
1787542012	879 Count	742 Count	262 Count
1787540219	878 Count	742 Count	262 Count
1787538418	877 Count	742 Count	262 Count
1787536618	876 Count	742 Count	262 Count
1787534817	875 Count	742 Count	262 Count
1787533016	874 Count	742 Count	262 Count
1787531216	873 Count	742 Count	262 Count
1787529415	872 Count	742 Count	262 Count
1787527614	871 Count	742 Count	262 Count
1787525813	870 Count	742 Count	262 Count
1787524013	869 Count	742 Count	262 Count
1787522309	868 Count	742 Count	262 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)