SR8ULZ-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR8ULZ-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1784698687	478 Count	176 Count	176 Count
1784696886	476 Count	175 Count	175 Count
1784695086	474 Count	174 Count	174 Count
1784693285	472 Count	173 Count	173 Count
1784691484	470 Count	172 Count	172 Count
1784689684	468 Count	171 Count	171 Count
1784687890	462 Count	170 Count	170 Count
1784686089	460 Count	169 Count	169 Count
1784684289	458 Count	168 Count	168 Count
1784682488	456 Count	167 Count	167 Count
1784680687	454 Count	166 Count	166 Count
1784678887	452 Count	165 Count	165 Count
1784677086	450 Count	164 Count	164 Count
1784675285	448 Count	163 Count	163 Count
1784673485	446 Count	162 Count	162 Count
1784671684	444 Count	161 Count	161 Count
1784669884	442 Count	160 Count	160 Count
1784668083	440 Count	159 Count	159 Count
1784666289	434 Count	158 Count	158 Count
1784664488	432 Count	157 Count	157 Count
1784662688	430 Count	156 Count	156 Count
1784660887	428 Count	155 Count	155 Count
1784659087	426 Count	154 Count	154 Count
1784657286	424 Count	153 Count	153 Count
1784655485	422 Count	152 Count	152 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)