PD2ATG-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PD2ATG-3. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RX*	Digi*
1762364737	42 Count	39 Count
1762362937	42 Count	39 Count
1762361137	42 Count	39 Count
1762359336	42 Count	39 Count
1762357536	42 Count	39 Count
1762355736	42 Count	39 Count
1762353936	30 Count	27 Count
1762352136	26 Count	23 Count
1762350335	26 Count	23 Count
1762348535	26 Count	23 Count
1762343135	26 Count	23 Count
1762341335	26 Count	23 Count
1762339535	26 Count	23 Count
1762337735	26 Count	23 Count
1762335934	26 Count	23 Count
1762334134	26 Count	23 Count
1762332334	26 Count	23 Count
1762330534	26 Count	23 Count
1762328734	26 Count	23 Count
1762326935	26 Count	23 Count
1762325135	26 Count	23 Count
1762323335	14 Count	11 Count
1762321535	14 Count	11 Count
1762319735	14 Count	11 Count
1762317935	14 Count	11 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)