IW0EFI-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IW0EFI-11. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1772590280	427 Count	33 Count
1772589380	428 Count	33 Count
1772588480	428 Count	33 Count
1772587579	428 Count	33 Count
1772586679	426 Count	33 Count
1772584879	427 Count	33 Count
1772583979	425 Count	34 Count
1772583078	427 Count	33 Count
1772582178	424 Count	34 Count
1772581278	425 Count	33 Count
1772580378	426 Count	33 Count
1772579478	428 Count	33 Count
1772578578	427 Count	33 Count
1772577677	426 Count	33 Count
1772575877	427 Count	33 Count
1772574977	426 Count	33 Count
1772574077	428 Count	33 Count
1772573176	427 Count	33 Count
1772572276	428 Count	33 Count
1772571376	428 Count	33 Count
1772570476	428 Count	33 Count
1772569576	427 Count	33 Count
1772568675	427 Count	33 Count
1772567775	428 Count	33 Count
1772566875	426 Count	33 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)