SP5RT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5RT-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1762290193	381 Count	737 Count	272 Count
1762289593	378 Count	734 Count	270 Count
1762287791	369 Count	722 Count	264 Count
1762286589	363 Count	710 Count	260 Count
1762285989	360 Count	702 Count	258 Count
1762285388	356 Count	695 Count	255 Count
1762284787	354 Count	692 Count	254 Count
1762284187	352 Count	687 Count	253 Count
1762274389	265 Count	434 Count	198 Count
1762273789	258 Count	416 Count	195 Count
1762273188	253 Count	406 Count	191 Count
1762272588	249 Count	392 Count	188 Count
1762271987	229 Count	337 Count	169 Count
1762270795	148 Count	194 Count	90 Count
1762270185	142 Count	166 Count	85 Count
1762269585	117 Count	128 Count	62 Count
1762269443	97 Count	110 Count	47 Count
1762269300	84 Count	92 Count	41 Count
1762269041	82 Count	78 Count	40 Count
1762268954	80 Count	76 Count	40 Count
1762268852	79 Count	76 Count	40 Count
1762268256	75 Count	70 Count	37 Count
1762267651	71 Count	63 Count	34 Count
1762267225	63 Count	50 Count	27 Count
1762266624	57 Count	41 Count	22 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)