SQ6NCN-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ6NCN-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1762366768	213 Count	852 Count	183 Count
1762364967	208 Count	819 Count	179 Count
1762363167	201 Count	781 Count	173 Count
1762361366	197 Count	759 Count	170 Count
1762357772	189 Count	708 Count	164 Count
1762355972	185 Count	670 Count	161 Count
1762354171	162 Count	616 Count	139 Count
1762352370	127 Count	532 Count	105 Count
1762350570	123 Count	510 Count	102 Count
1762348769	119 Count	488 Count	99 Count
1762345168	108 Count	442 Count	90 Count
1762343367	104 Count	421 Count	87 Count
1762341567	100 Count	402 Count	84 Count
1762339766	95 Count	378 Count	80 Count
1762337965	90 Count	356 Count	76 Count
1762336171	86 Count	334 Count	73 Count
1762334370	82 Count	314 Count	70 Count
1762332569	76 Count	290 Count	65 Count
1762330769	70 Count	269 Count	60 Count
1762328968	64 Count	246 Count	55 Count
1762327167	60 Count	226 Count	52 Count
1762325367	56 Count	208 Count	49 Count
1762323566	52 Count	188 Count	46 Count
1762321766	45 Count	162 Count	40 Count
1762319964	19 Count	97 Count	15 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)