VU2TGG-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VU2TGG-11. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Vin*	Eff1h*
1788576366	12.45 Volt	100 Pcnt
1788576066	12.45 Volt	100 Pcnt
1788575766	12.45 Volt	100 Pcnt
1788575466	12.45 Volt	100 Pcnt
1788575166	12.45 Volt	100 Pcnt
1788574866	12.45 Volt	100 Pcnt
1788574566	12.45 Volt	100 Pcnt
1788574302	12.45 Volt	100 Pcnt
1788573966	12.45 Volt	100 Pcnt
1788573666	12.45 Volt	100 Pcnt
1788573366	12.45 Volt	100 Pcnt
1788573066	12.45 Volt	100 Pcnt
1788572766	12.45 Volt	100 Pcnt
1788572466	12.45 Volt	100 Pcnt
1788572166	12.45 Volt	100 Pcnt
1788571866	12.45 Volt	100 Pcnt
1788571566	12.45 Volt	100 Pcnt
1788571266	12.45 Volt	100 Pcnt
1788570966	12.45 Volt	100 Pcnt
1788570666	12.45 Volt	100 Pcnt
1788570366	12.45 Volt	100 Pcnt
1788570066	12.45 Volt	100 Pcnt
1788569766	12.45 Volt	100 Pcnt
1788569466	12.45 Volt	100 Pcnt
1788569166	12.45 Volt	100 Pcnt

*Used Equation Coefficients:

Vin: 0, 0.075, 0

Rx1h: 0, 10, 0

Dg1h: 0, 10, 0

Eff1h: 0, 1, 0

A5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)