SK3VJ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SK3VJ-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789975086	273 Count	984 Count	248 Count
1789973279	258 Count	933 Count	234 Count
1789971476	244 Count	881 Count	221 Count
1789969673	230 Count	833 Count	208 Count
1789967870	216 Count	778 Count	195 Count
1789966101	198 Count	723 Count	182 Count
1789964298	185 Count	675 Count	170 Count
1789962494	172 Count	601 Count	158 Count
1789960691	156 Count	551 Count	143 Count
1789958888	142 Count	497 Count	130 Count
1789957085	128 Count	445 Count	117 Count
1789955282	113 Count	392 Count	103 Count
1789953479	97 Count	332 Count	88 Count
1789951676	82 Count	280 Count	74 Count
1789949873	67 Count	222 Count	60 Count
1789948070	51 Count	170 Count	45 Count
1789946267	35 Count	112 Count	30 Count
1789944498	16 Count	60 Count	16 Count
1789942695	254 Count	1043 Count	234 Count
1789940892	239 Count	986 Count	220 Count
1789939089	223 Count	927 Count	205 Count
1789937286	209 Count	870 Count	192 Count
1789935483	194 Count	810 Count	178 Count
1789933679	178 Count	751 Count	163 Count
1789931876	164 Count	695 Count	150 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)