AJ6WO-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object AJ6WO-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1781890354	199 Count	255 Count	87 Count
1781889751	198 Count	253 Count	87 Count
1781889148	192 Count	246 Count	82 Count
1781888544	189 Count	242 Count	80 Count
1781887941	188 Count	240 Count	80 Count
1781887337	187 Count	238 Count	80 Count
1781886734	185 Count	235 Count	79 Count
1781886131	184 Count	233 Count	79 Count
1781885527	183 Count	231 Count	79 Count
1781884924	180 Count	227 Count	77 Count
1781884321	179 Count	225 Count	77 Count
1781883717	177 Count	222 Count	76 Count
1781883114	176 Count	220 Count	76 Count
1781882511	175 Count	218 Count	76 Count
1781881907	170 Count	212 Count	72 Count
1781881304	165 Count	206 Count	68 Count
1781880700	161 Count	201 Count	65 Count
1781880097	159 Count	198 Count	64 Count
1781879494	156 Count	194 Count	62 Count
1781878890	155 Count	192 Count	62 Count
1781878287	153 Count	189 Count	61 Count
1781877684	151 Count	186 Count	60 Count
1781855599	99 Count	153 Count	45 Count
1781854996	96 Count	151 Count	43 Count
1781854393	95 Count	149 Count	43 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)