SQ5K-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ5K-9. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	V_Bat*
1765335253	131 Count	4.1 VDC
1765333452	130 Count	4.1 VDC
1765331651	129 Count	4.1 VDC
1765329857	128 Count	4.09 VDC
1765328057	127 Count	4.1 VDC
1765326256	126 Count	4.1 VDC
1765324472	125 Count	4.1 VDC
1765322655	124 Count	4.09 VDC
1765320854	123 Count	4.1 VDC
1765319054	122 Count	4.1 VDC
1765317253	121 Count	4.1 VDC
1765315459	120 Count	4.09 VDC
1765313652	119 Count	4.1 VDC
1765311851	118 Count	4.1 VDC
1765310050	117 Count	4.1 VDC
1765308257	116 Count	4.1 VDC
1765306465	115 Count	4.1 VDC
1765304656	114 Count	4.1 VDC
1765302855	113 Count	4.1 VDC
1765301055	112 Count	4.1 VDC
1765299254	111 Count	4.09 VDC
1765297453	110 Count	4.1 VDC
1765295653	109 Count	4.1 VDC
1765293852	108 Count	4.1 VDC
1765292051	107 Count	4.1 VDC

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)