SR9EMP Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR9EMP. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1763161574	115 Count	912 Count	110 Count
1763159773	95 Count	740 Count	91 Count
1763157973	74 Count	580 Count	71 Count
1763156172	53 Count	401 Count	51 Count
1763154371	29 Count	212 Count	28 Count
1763152579	138 Count	1180 Count	134 Count
1763149010	77 Count	666 Count	75 Count
1763147177	56 Count	464 Count	55 Count
1763145376	23 Count	192 Count	23 Count
1763143575	119 Count	1039 Count	116 Count
1763141773	98 Count	850 Count	96 Count
1763138172	29 Count	308 Count	29 Count
1763134570	108 Count	844 Count	106 Count
1763130981	28 Count	238 Count	28 Count
1763129179	132 Count	1202 Count	128 Count
1763127379	106 Count	933 Count	103 Count
1763125608	70 Count	614 Count	68 Count
1763123777	40 Count	357 Count	39 Count
1763121976	20 Count	193 Count	20 Count
1763120175	121 Count	1104 Count	115 Count
1763112970	47 Count	383 Count	46 Count
1763111168	27 Count	206 Count	27 Count
1763109378	144 Count	1091 Count	141 Count
1763107577	98 Count	828 Count	96 Count
1763105776	65 Count	637 Count	64 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)