SP2WM-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2WM-11. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1784705384	286 Count	342 Count	75 Count
1784704483	284 Count	333 Count	74 Count
1784703582	282 Count	330 Count	73 Count
1784702681	281 Count	330 Count	73 Count
1784701781	280 Count	330 Count	73 Count
1784700880	279 Count	330 Count	73 Count
1784699979	278 Count	330 Count	73 Count
1784699078	277 Count	330 Count	73 Count
1784698178	276 Count	330 Count	73 Count
1784697277	275 Count	330 Count	73 Count
1784696376	274 Count	330 Count	73 Count
1784695475	273 Count	330 Count	73 Count
1784694574	272 Count	330 Count	73 Count
1784693674	271 Count	330 Count	73 Count
1784692773	270 Count	330 Count	73 Count
1784691872	269 Count	330 Count	73 Count
1784690971	268 Count	330 Count	73 Count
1784690070	267 Count	330 Count	73 Count
1784689170	266 Count	330 Count	73 Count
1784688275	265 Count	330 Count	73 Count
1784687368	264 Count	330 Count	73 Count
1784686467	263 Count	330 Count	73 Count
1784684666	261 Count	330 Count	73 Count
1784683783	256 Count	330 Count	73 Count
1784682882	255 Count	330 Count	73 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)