F5ZYM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F5ZYM-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1784623244	171 Count	271 Count	141 Count
1784622340	167 Count	263 Count	138 Count
1784621436	163 Count	255 Count	135 Count
1784620532	158 Count	248 Count	131 Count
1784619628	154 Count	241 Count	128 Count
1784618724	148 Count	232 Count	123 Count
1784617820	144 Count	225 Count	120 Count
1784616916	141 Count	218 Count	118 Count
1784616012	134 Count	206 Count	112 Count
1784615108	128 Count	197 Count	107 Count
1784614203	122 Count	188 Count	102 Count
1784613299	116 Count	180 Count	97 Count
1784612395	111 Count	172 Count	93 Count
1784611594	104 Count	162 Count	87 Count
1784610690	98 Count	154 Count	82 Count
1784609786	91 Count	145 Count	76 Count
1784608882	86 Count	137 Count	72 Count
1784607978	79 Count	126 Count	66 Count
1784607074	73 Count	116 Count	61 Count
1784606169	69 Count	102 Count	58 Count
1784605265	63 Count	93 Count	53 Count
1784604361	57 Count	83 Count	48 Count
1784603457	51 Count	75 Count	43 Count
1784602553	45 Count	65 Count	38 Count
1784601649	40 Count	59 Count	34 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)