SP2YRY-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2YRY-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1782597237	140 Count	81 Count	3 Count
1782593634	138 Count	81 Count	3 Count
1782590031	136 Count	81 Count	3 Count
1782586473	134 Count	81 Count	3 Count
1782582885	132 Count	81 Count	3 Count
1782579268	130 Count	81 Count	3 Count
1782575665	128 Count	81 Count	3 Count
1782572063	126 Count	81 Count	3 Count
1782568460	124 Count	81 Count	3 Count
1782544113	121 Count	81 Count	3 Count
1782540510	119 Count	81 Count	3 Count
1782536922	117 Count	81 Count	3 Count
1782533319	115 Count	81 Count	3 Count
1782529717	113 Count	81 Count	3 Count
1782526114	111 Count	81 Count	3 Count
1782522512	109 Count	81 Count	3 Count
1782518911	107 Count	81 Count	3 Count
1782515325	105 Count	81 Count	3 Count
1782511722	103 Count	81 Count	3 Count
1782508118	101 Count	81 Count	3 Count
1782504514	99 Count	81 Count	3 Count
1782500911	97 Count	81 Count	3 Count
1782497309	95 Count	81 Count	3 Count
1782493720	93 Count	81 Count	3 Count
1782490117	91 Count	81 Count	3 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)