SP3KON-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3KON-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1776544282	304 Count	840 Count	111 Count
1776543381	299 Count	830 Count	107 Count
1776542480	296 Count	820 Count	105 Count
1776541580	292 Count	809 Count	102 Count
1776540679	288 Count	796 Count	99 Count
1776539778	285 Count	788 Count	97 Count
1776538877	281 Count	780 Count	94 Count
1776523618	280 Count	780 Count	94 Count
1776522718	277 Count	766 Count	92 Count
1776521818	271 Count	749 Count	87 Count
1776520940	268 Count	730 Count	85 Count
1776520039	262 Count	719 Count	82 Count
1776519138	258 Count	690 Count	79 Count
1776518237	254 Count	678 Count	76 Count
1776517337	251 Count	669 Count	74 Count
1776516435	248 Count	658 Count	72 Count
1776515534	243 Count	631 Count	68 Count
1776514633	240 Count	592 Count	66 Count
1776513732	237 Count	560 Count	64 Count
1776512831	234 Count	551 Count	62 Count
1776511930	230 Count	540 Count	59 Count
1776511029	227 Count	531 Count	57 Count
1776510128	223 Count	520 Count	54 Count
1776509227	219 Count	492 Count	51 Count
1776508327	217 Count	481 Count	50 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)