HB9JAY-96 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object HB9JAY-96. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Temp.in*	Temp.out*
1785261388	0 C deg	34.4 C deg
1785259573	0 C deg	35.9 C deg
1785257758	0 C deg	37.6 C deg
1785255943	0 C deg	36.6 C deg
1785254128	0 C deg	34.9 C deg
1785252313	0 C deg	33.8 C deg
1785250497	0 C deg	33.6 C deg
1785248682	0 C deg	33.1 C deg
1785246867	0 C deg	30.8 C deg
1785245052	0 C deg	30.1 C deg
1785243237	0 C deg	29.6 C deg
1785241422	0 C deg	28.4 C deg
1785239607	0 C deg	28.4 C deg
1785237792	0 C deg	27.2 C deg
1785235977	0 C deg	26.2 C deg
1785234162	0 C deg	25.2 C deg
1785232347	0 C deg	24.9 C deg
1785230532	0 C deg	24.8 C deg
1785228717	0 C deg	23.6 C deg
1785226902	0 C deg	22.9 C deg
1785225087	0 C deg	22.9 C deg
1785223271	0 C deg	21.4 C deg
1785221456	0 C deg	20.7 C deg
1785219641	0 C deg	20.4 C deg
1785217826	0 C deg	19.1 C deg

*Used Equation Coefficients:

Press: 0, 1, 0

Temp.in: 0, 1, 0

Hum: 0, 1, 0

QNH: 0, 1, 0

Temp.out: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)